Veneer peeling machine is a kind of mechanical equipment for veneer veneer in wood manufacturers, but it can't cut the remaining wood section, resulting in a waste of resources. Now we carefully understand the knowledge of card free veneer peeling machine, right?
The minimum setting value should not be less than 30mm when setting the minimum processing residual wood segment, otherwise it will easily lead to machine failure. When setting the stop point, the upper limit of the set value shall not exceed the maximum stroke of the equipment, and the lower limit shall not be less than the set value of the machining surplus, otherwise the machine will not work. The veneer peeling machine cutter should be used within the scope of application specified in the technical characteristics. Some manufacturers use it to cut plastic for drawing convenience, resulting in serious deformation of the plastic, and also damage the use of the veneer peeling machine, so don't want to use more than one machine.
After each use of the veneer peeling machine, the upper and lower waste materials should be removed, so as not to cause the machine to jam, but also affect the rotary cutting efficiency and the service life of the machine.