Veneer with card rotary cutting machine as a wood processing machinery has been loved by the majority of consumers, but when using the card rotary cutting machine, there will be some problems that make us very headache. For example, the wood is stuck by the machine is a problem we often encounter, so how do we solve this problem? Let's analyze the factors that cause this situation?
Let's understand that the saw blade is not tightened or the saw blade is aging and there is no saw path; the belt or transmission gear slips or is damaged and needs to be adjusted or replaced; the wood is too hard and does not match the machine power, such as the motor is too small or the input circuit core is too thin and the voltage is too low, and the speed is not enough.
Of course, there are many other factors. The angle of the cutter head or saw blade needs to be adjusted to reduce the excessive resistance, and the blade or blade needs to be polished to ensure the sharpness. The user can carry out the investigation one by one according to the specific situation, and the root cause of the problem should be found. Use wood veneer to have card when the rotary cutting machine is stuck, how to return a responsibility?
In such a case, the machine should be shut down and cut off first, and then check the cause of jamming. Generally, it is necessary to check whether the saw blade is not tightened, or the saw blade is not sharp for a long time, or the belt is slipping or damaged. Adjust and replace it according to the situation, or the hardness of the processed wood is too high, the machine is too hard, and the power of the machine is small, resulting in stuck, cutter head installation angle If the problem is not sharp enough, it should be dealt with according to the situation. The cause of the problem will be found after checking one by one. Don't disassemble blindly to avoid secondary damage. The fundamental problem can be solved by applying the right medicine to the case.