The wear effect of the vulnerable parts of the rotary cutting machine

If the wearing effect of the vulnerable parts of the rotary cutting machine, there are many vulnerable parts that can come from the rotary cutting machine, and they mainly come from the feed lead screw, the clamping shaft and the shaft sleeve, the main slide way and the slide block, the dipstick holder, the matching surface of the tool holder, etc., then they can come from the serious wearing of these vulnerable parts, which will reduce the accuracy of the equipment, and they can come from the rotary cutting machine There will also be a quality impact on the veneer.

If the feed screw or nut is worn, the tool holder will be loose, and the thickness of the veneer will be different when the feed screw or nut is worn, and if the chuck shaft and the shaft sleeve are worn, the shaft will be loose, then the rotation will be out of round, and if the feed screw or nut is worn, then the veneer thickness will be different It is possible to generate wear on the main slide that will change the cutting angle of the rotary cutting tool during the rotary cutting, so as to cause the thickness of the outer circle single plate, the thickness of the inner circle, or the waviness of the outer circle. It is possible to generate severe wear on the surface of the caliper holder or the tool holder, so as to generate horizontal sliding, and it is also possible to generate wood during the rotary cutting Push the pressure gauge back.

-------------END-------------