Of course, there are many other factors. The angle of the blade or saw blade needs to be adjusted to reduce the excessive resistance, and the blade or saw blade needs to be polished to ensure the sharpness. Users can conduct troubleshooting one by one according to the specific situation, and should find the root cause of the problem. Veneer rotary cutting machine manufacturers have stuck when using veneer card rotary cutting machine, what's the matter?
In such a case, firstly shut down the machine and cut off the power supply. Then check the cause of jamming. Generally, it is necessary to check whether the saw blade is not tightened, or whether the saw blade has been used for too long and is not sharp, the belt is slipping or damaged. Adjust and replace it according to the situation, or the hardness of the processed wood is too high and the machine is too laborious.
If the power of the machine is small and the installation angle of the cutter head is not sharp enough, the problem will be solved according to the situation. After troubleshooting one by one, the cause of the problem will be found. Do not disassemble blindly to avoid secondary damage. Only by taking the right medicine can the fundamental problem be solved.
Veneer rotary cutting machine manufacturers as wood processing machinery are loved by the majority of consumers, but when using the card rotary cutting machine, we should also pay attention to the maintenance of the machine. If you have other problems, you can contact our company at any time through the above brief introduction.